BODY/STEERING/SUSPENSION
4.13
8. Open the throttle ETC switch box and lightly grease
the throttle cable (A). Install the throttle cable.
Electronic Throttle Control (ETC) Switch
ETC Micro
Switch Button
A
(Cast Aluminum Throttle Housing)
9. Connect the wiring harness to the three color
coordinated wires.
Wires and Harness
10. Install the upper pod assembly with the screws.
Torque the pod screws to specification.
Pod Mounting Screw Torque:
42in.lbs.(4.7Nm)
SCRAMBLER HANDLEBAR
ASSEMBL
Y
ROUND NUTS
PROTECTIVE PADDING
HANDLEBAR
HANDLEBAR
COVER
CLAMPS
WASHER
NUT
BOLTS
Brake
Lever
Right Hand Control
Handlebar
Grip
SPACERS
1. Install the lower clamps.
2. The handlebar assembly includes the right and left
side brake levers, the throttle control and the left
side control switch. Install these items loosely on
the handle bar before mounting. Avoid pulling or
bending wires and brake cable..
NOTE: Connect the wiring harness and wires before
the handlebar cover is installed. Be sure the cables
and wires are routed properly.
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
