BODY/STEERING/SUSPENSION
4.9
11. Set the chaintension to specification by loosening
the lock nuts on the chain adjuster. Turn the
adjuster until the chain tension is set. Tighten the
adjuster nuts.
Chain Adjuster
Chain Tension Specification:
.40-.80² (10-20 mm) slack
Chain Tensioner Nut Torque:
84 in.lbs. (10 Nm)
12. Tighten all bearing carrier bolts to specification.
Carrier Bolts
Bearing Carrier Bolt Torque:
43 ft.lbs. (60 Nm)
13. Install the rear cover. Torquebolts to specification
Rear Cover
Rear Cover Bolt Torque:
84 in.lbs. (10Nm)
FUEL AND OIL TANK
1. Install fuel tank in the frame and tighten bolts to
specification. Make sure the fuel tank pads are in
place and in good condition and the vent line is
unobstructed.
Fuel Tank Mounting Bolt Torque:
103 in.lbs. (12 Nm)
2. Install the oil tank to the frame and tighten bolts to
specification. Always fill the oil reservoir before
riding.
Oil Tank Mounting Bolt Torque:
103 in.lbs. (12 Nm)
3. The fuel petcock has “ON”, “OFF”, and “RES”.
Make note of these positions on the petcock.
Always turn fuel off when transporting an ATV.
OFF
RES
ON
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
