Polaris SCRAMBLER 90 User Manual

BODY/STEERING/SUSPENSION
4.7
3. Mount the front brake assembly on the spindle.
4. Mount the brake drum on the backing plate
assembly and tighten the spindle nut to
specification.
Spindle Nut Torque:
42-45 ft.lbs. (58-62 Nm)
5. Connect the brake cable with brake arm.
6. Install the rubber cap.
REAR BRAKE AND AXLE
Rear Brake Cable
Rear Brake Drum
Rubber Gasket
Brake Shoes
Brake Cam Shaft
Bearing Carrier
Brake Arm Spring
Rear Brake
Arm
Spacer Tube
Protective Cover
Rear Cover Plates
Rear Cover
1. Apply grease to the swing arm spacer tube. The
swing arm assembly must be mounted first.
NOTE: The swing arm assembly includes chain
protector.
2. Install the swing arm to the frame and tighten the
mounting bolt to specification. Install rear shock
and spring. Tighten shock mounting bolts to
specification.
Swing Arm Mounting Bolt Torque:
26-30 ft.lbs. (36-40 Nm)
Rear Shock Mounting Bolt Torque:
25 ft.lbs. (35 Nm)
3. Inspect the protective rubber gasket on the rear
brake drum for damage. Replace if needed.
Mount the rear brake plate, shoes, and springs on
the bearing carrier. Install the brake drum.
Rear Brake Plate
Rear Brake Shoes
Rear Brake Drum
Rubber Gasket
Enfocus Software - Customer Support

Polaris SCRAMBLER 90 Specifications

General

Brand	Polaris
Model	SCRAMBLER 90
Category	Offroad Vehicle
Language	English