Polycom VSX Series Integrator's Reference Manual

Chapter 3 - System Commands
© Polycom, Inc. 3 - 69
ISDN Commands
Command Syntax Description Example
areacode areacode <set|get>
areacode set [“code”]
Where:
• set: Sets the ISDN BRI area code
when followed by the area code
parameter. If you want to erase the
current setting, omit area code.
•get: Returns the area code
information.
•“code”: Area code to use for all BRI
lines.
Sets the area code for all ISDN
BRI lines. This code is
associated with the area where
the VSX system is used.
User interface screen location:
System > Admin Settings >
Network > ISDN (page 2):
Area Code (for Line 1, Line 2,
Line 3, and Line 4)
areacode get
returns information
similar to this:
areacode 212
bri1enable,
bri2enable,
bri3enable,
bri4enable
bri1enable <yes|no|get>
bri2enable <yes|no|get>
bri3enable <yes|no|get>
bri4enable <yes|no|get>
Where:
•yes: Enables the BRI line.
•no: Disables the BRI line.
•get: Returns the status of the BRI
line—yes if enabled, no if disabled.
Enables or disables the ISDN
BRI line specified in the
command name.
User interface screen location:
System > Admin Settings >
Network > ISDN (page 2):
Enable (for each line)
bri1enable yes
briallenable briallenable <yes|no|get>
Where:
•yes: Enables all BRI lines.
•no: Disables all BRI lines.
•get: Returns the status of all BRI
lines—yes if enabled, no if disabled.
Enables or disables all ISDN
BRI lines.
User interface screen location:
System > Admin Settings >
Network > ISDN (page 2):
Enable (for Line 1, Line 2, Line
3, and Line 4)
briallenable yes
cts cts <normal|inverted|get>
Where:
• normal: Sets the signal to normal
(high voltage is logic 1).
• inverted: Sets the signal to inverted
(low voltage is logic 1).
• get: Returns the current setting
(normal or inverted).
Lets you configure the cts serial
interface control signal (clear to
send). The default setting for
this signal is “normal”.
User interface screen location:
System > Admin Settings >
Network > IP > H.323 Set-
tings> V.35/RS-449/RS-530
(page 3): CTS
cts normal
dcd dcd <normal|inverted|get>
Where:
• normal: Sets the signal to normal
(high voltage is logic 1).
• inverted: Sets the signal to inverted
(low voltage is logic 1).
• get: Returns the current setting
(normal or inverted).
Lets you configure the dcd serial
interface control signal (data
carrier detect). The default
setting for this signal is “normal”.
User interface screen location:
System > Admin Settings >
Network >
V.35/RS-449/RS-530 (page 3):
DCD
dcd inverted

Polycom VSX Series Specifications

General

Brand	Polycom
Model	VSX Series
Category	Conference System
Language	English