4 Label Stock
A. Label and Roll Specifications
A wide variety of label stock can be used in the Printer. Refer to the specifications and
settings in the following sections before ordering custom stock from Primera or any stock
from another company.
Important! Test all custom made label stock with the intended printer before ordering large quantities! Primera will
only assume responsibility for custom label stock ordered from Primera.
Note: See table on the next page for Max and Min values in inches and mm.
Section 2: Label Stock
Label Width
Liner Width
Distance from
edge of Media
to edge of Label
Width of Opening
Black Mark
Width
Gap Between
Labels
Label Height
Distance from
edge of Media
Label Sensing Methods
Method
1: Label
2: Thru-Hole
3: Reflective/Black
Mark Sensing
(Black Mark must be printed
on back side of label stock)
Note: See table below for Max and Min values in inches and mm.
A black mark is typically needed
for clear labels or any label that
does not have an easily
detectable gap between labels.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
