72-910-16 Rev. N
Page 18 of 43
7.5 Status Screen
This screen shows the real-time data relating to the controller. This screen can be used
to log the amount of time a particular output was energized since it was last reset.
Below is a description of each of the data fields:
Water Meter – The amount of water that has been registered by the controllers water
meter input.
Bleed – The amount of time, in hours, the bleed output was energized since it was last
reset.
Inhib – The amount of time, in hours, the inhibitor output was energized since it was last
reset.
BioA – The amount of time, in hours, the biocide-A output was energized since it was
last reset.
BioB – The amount of time, in hours, the biocide-B output was energized since it was
last reset.
Probe Temp – Current probe temperature in Celsius.
Last Error – Shows the most recent error that was displayed on the controller.
Pressing the reset key will cause the hour timers and water meter to reset to zero.
7.6 Configure Menu
From the Configure menu you can select many different system configuration options.
Date/Time
HOA Outputs
Water Meter
Language
Drum Levels
Disp Damp
Rise/Fall
Contrast
Password
Troubleshoot
Software Ver
Factory Rst
Back | Select
Water Meter: 0000000000
Bleed: 123.4 Inhib 123.4
BioA: 123.4 BioB 123.4
Probe Temp: 24.4 C
Last Error: Low Flow
Back | Reset
To Next Page
Loading...
Need help?
General
