NB-IoT Module Series
BC95 AT Commands Manual
BC95_AT_Commands_Manual Confidential / Released 40 / 58
4.7. AT+NRB Neul Reboot
This command reboots the terminal. There is a short delay after issuing this command before the terminal
reboots. No further AT commands will be processed. Refer to Chapter 6 for possible <err> values.
Please note that there is no final OK to signal that the command line has finished processing as AT
command processing terminates with this command. No confirmation messages are expected until the
reboot.
Example
AT+NRB
REBOOTING
4.8. AT+NCDP Configure and Query CDP Server Settings
This command is used to set and query the server IP address and port for the Connected Device Platform
(CDP) server. It is used when there is a Neul CDP or Huawei IoT platform acting as gateway to network
server applications. Refer to Chapter 6 for possible <err> values.
AT+NCDP Configure and Query CDP Server Settings
Set Command
AT+NCDP=<ip_addr>[,<port>]
Response
Update the CDP server configuration from the supplied
parameters. If they are set correctly, return OK. If it fails, an
error is returned.
+CME ERROR: <err>
Response
Return the current CDP server IP address and port. Return an
error if not set.
OK
+CME ERROR: <err>
To Next Page
Loading...
Need help?
General
