LTE Standard Module Series
10 Warnings sentences
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to
Part 2.1091(b).
3. The separate approval is required for all other operating configurations,
including portable configurations with respect to Part 2.1093 and different
antenna configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for
additional testing to verify compliance as a composite system. When testing the
host device for compliance with Part 15 Subpart B, the host manufacturer is
required to show compliance with Part 15 Subpart B while the transmitter
module(s) are installed and operating. The modules should be transmitting and
the evaluation should confirm that the module's intentional emissions are
compliant (i.e. fundamental and out of band emissions). The host manufacturer
must verify that there are no additional unintentional emissions other than what
is permitted in Part 15 Subpart B or emissions are complaint with the
transmitter(s) rule(s). The Grantee will provide guidance to the host
manufacturer for Part 15 B requirements if needed.
⚫ End Product Labeling
When the module is installed in the host device, the FCC ID label must be visible through a
window on the final device or it must be visible when an access panel, door or cover is easily
re-moved. If not, a second label must be placed on the outside of the final device that contains
the following text:
“Contains FCC ID: XMR202112EC200AAU”
The FCC ID can be used only when all FCC compliance requirements are met.
Wideband Code Division Multiple Access
To Next Page
Loading...
Need help?
General
