GSM/GPRS/GNSS Module Series
MC60 Series Hardware Design
MC60_Series_Hardware_Design Confidential / Released 50 / 114
send an AT string in order that the GSM module can detect baud rate of host controller, and it should
continue to send the next AT string until receiving OK string from the module. Then enter
AT+IPR=x;&W to set a fixed baud rate for the module and save the configuration to flash memory of
the module. After these configurations, the URC RDY would be received from the UART Port of the
GSM module every time when the module is powered on. For more details, refer to the section
AT+IPR in document [1].
2. When AT command is responded, it indicates the GSM module is turned on successfully; or else the
module fails to be turned on.
The other way to control the PWRKEY is through a button directly. While pressing the key, electrostatic
strike may generate from the finger, and thus, a TVS component is indispensable to be placed nearby the
button for ESD protection. For the best performance, the TVS component must be placed nearby the
button. A reference circuit is shown in Figure 17.
The turn-on timing is illustrated in the following figure.
VDD_EXT
(OUTPUT)
V
IL
<0.1*VBAT
V
IH
> 0.6*VBAT
VBAT
PWRKEY
(INPUT)
54ms
>1s
T
1
OFF
BOOTING
GSM PART STATUS
RUNNING
Figure 21: Turn-on Timing of GSM Part
Make sure that VBAT is stable before pulling down PWRKEY pin. The time of T
1
is recommended to be
100ms.
To Next Page
Loading...
Need help?
General
