Quicksilver 875SD User Manual

33
Quicksilver 875SD — System & Component Overview and Operaon
Fuel burning open ame appliances consume cabin oxygen
and release products of combuson into the cra.
Venlaon is required when appliances are in use. Open
designated vent openings while appliances are in use. Do
not use the stove or oven space heang. Never obstruct
venlaon openings.
Do not use soluons containing Ammonia
Never use ames to check for leaks
system is present. IF PRESSURE GAUGE READING FALLS, LEAK IS PRESENT. DO NOT USE LPG
APPLIANCES.
2. Roune observaon of bubble leak detector (if ed on the system).
3. Manual leak tesng with foam-producing, soapy water or detergent soluons (with appliance
burner valves closed and cylinder and system valves open); foam-producing soluons for leak
detecon on gas installaons in accordance with EN 14291 meet these requirements.
If a leak is present, shut o the LPG supply at the main supply valve. Exnguish any open ames
(heaters, stoves, etc.) and do not operate any electric switches. Finally, evacuate the area if possible.
Quicksilver® recommends that any LPG system repairs should be made by your authorized
Quicksilver® dealer.
Do not use an LPG system that has leaked unl it has been
inspected and repaired by a competent person.
If a leak is detected, shut o the main LPG supply valve and
do not use LPG appliances
Changing LPG Cylinders
To replace empty LPG cylinder:
1. Turn o the stove and close the shuto valve.
2. Close the valve on the LPG cylinder.
3. Remove the regulator by turning the nut clockwise.
4. Replace the empty tank.
5. Inspect the regulator. Make sure that the gasket located on the regulator nut is in good
condion. If not, replace regulator gasket or regulator itself.
6. Re-install and ghten the regulator by turning the nut counterclockwise.
7. Check for any leaks before restarng the stove.
9. Electric Grill (oponal)
Instead of an LPG system, an electric grill opon is available at the cockpit entertainment center. The
electric grill is powered by shore power, and the COOK TOP breaker on the shore power panel must
be ON for the grill to funcon.
A concealed electric element eliminates grease are-ups and a reusable grease pan located under
the heang element collects all the fat and juices associated with grilling. The grease pan must be
emped aer each use.
To remove the grease pan:
1. Remove the grate
2. Li the heang element
3. Remove the grease pan
When replacing the pan, assure that it is completely contained within the grill and that the side of the
pan does not extend outside of the grill sides.

Quicksilver 875SD Specifications

General

Brand	Quicksilver
Model	875SD
Category	Boat
Language	English