47
Quicksilver 875SD — System & Component Overview and Operaon
25. Cockpit Table
Your boat comes equipped with a rectangular teak cockpit table. Also included are two removable
table legs, which when not in use, are stored on the cockpit oor access hatch. To install the table,
rst remove the plasc covers located in the table base plates. Next, push and lock the table legs into
the base plates. Finally, place the table onto the table legs. The table is hinged to all easy access to the
L-lounge seang. When not in use, the table can be placed in a convenient bag and stored in the bilge.
26. Sun Lounge Conversion (oponal)
As a supplement to the L-lounge seat in the cockpit, an oponal sun lounge conversion is available.
This consists of two addional table legs and an upholstery cushion. When not in use, the two short
table legs are stored on the cockpit oor access hatch.
To install the sun lounge, rst remove the plasc covers located in the table base plates. Next, push
and lock the short table legs into the base plates. Next, push and lock the short table legs into the
cockpit table. Now, place the table and table legs into the table bases in the cockpit oor. The table
will now sit in a lip located on the edge of the L-lounge. Snap the sun lounge cushion in place and
rotate the a lounge backrest 90 degrees.
Reclining A Lounge Seat
A Lounge Seat — Upright Posion
Do NOT run the boat while the a cockpit seat is laying at.
Quicksilver® recommends that when the engine is running,
the seat back is in it’s most up-right posion.
A Lounge Seat — 30 Degree Recline
A Lounge Seat — 90 Degree Recline
Reclining lever
To return the backrest to it’s most up-right posion, simply li the lever again and rotate the seat back
up.
To Next Page
Loading...
Need help?
General
