RADWAG R Series User Manual

- 39 -
• Start the balance with no load on the weighing pan (permissible value of load on the weighing
pan on balance start is ±10% of its maximum capacity).
• Load the weighing pan steadily avoiding shocks:
YES
NO
• Place weighed loads centrally on the weighing pan:
YES
NO
• Avoid side loading, in particular side shocks:
NO
NO
The balance requires adjusting before weighing process start or in case of drastic change of ambient
conditions at a workstation.
•
Before the start of weighing procedure, it is recommended to load the weighing pan a few times
with mass close to balance max capacity,
• Check if unloaded balance indicates “precise zero” and whether measurement is stable
, if not, press /Delete button,
• Press UNITS button, to set a measuring unit:
• Place weighed object on the weighing pan and read result only on measurement result
stabilization,
• Mass indication of a load placed on the weighing pan can be tared multiple number of times by
pressing →T
←
/Insert (pay CAUTION not to exceed maximal capacity of a balance by applying
multiple tare function).
The balance shall stay plugged to the mains in between measurement series. It is recommended to
switch off the balance display by pressing ON/OFF button. On repeated ON/OFF button pressing, the
balance is ready for operation and carrying out the following measurements.
11.2.2. Balance Zeroing
Zeroing is a function allowing to zero mass indication. In order to zero mass indication, press
button. Mass indication of zero value shall be displayed together with precise zero
and stability
markers.

RADWAG R Series Specifications

General

Brand	RADWAG
Model	R Series
Category	Scales
Language	English