To Next Page

To Previous Page

- 51 -

• Use arrow buttons to enter low threshold value, press button to confirm.

• The software automatically proceeds to the editing window of MAX high threshold value, which

is to be given in the current unit. Use arrow buttons to enter high threshold value, press

button to confirm.

• The balance software proceeds to <CHECKWEIGHING> mode, values of declared thresholds

are displayed in the bottom line (if such an option has been selected for <INFORMATION>

function).

• At the top of the display the message <Min> is shown, it indicates weight value placed on the

weighing pan in relation to low limit weight value. Bottom line of the display, if <BARGRAPH>

option is enabled, shall demonstrate weight indication, in a graphic form, in relation to set

thresholds.

<Min>: mass lower than the value of the low threshold

<Ok>: mass contained within thresholds

<Max>: mass higher than the value of the high threshold

Since LCD display capacity is limited, the threshold markers do not reflect threshold setups and

target weight value precisely. They provide rough information and serve as user aid in course of the

balance operation.

11.5. DOSING

Dosing mode comprises process of sample weighing, wherein the said sample weighing is performed

until target mass is reached. The target mass is defined along with dosing tolerance value. The

tolerance value is set as a percentage of the target mass.

An example:

Target weight = 100.000g

Tolerance = 2,5% (2,5% of 100g, which amounts to 2,5g)

i.e.: the software accepts correctly dosed value within the following thresholds: from 97,500g to

102,500g.

F Shortcut Keys

You can declare which particular weighing function is to be launched using F1, F2, F3 or F4 keys.

For procedure informing you how to declare the particular function, read F Shortcut Keys section.

11.5.1. Setting Target Mass: Entering Mass Value

Procedure:

• Press F button to which function <ENTER SAMPLE> is assigned, the editing window is

displayed. The target weight value must be given in a current unit.

RADWAG R Series User Manual

Questions and Answers: