CHAPTER 3
14 Miller Nitro 5000 Series & New Holland Guardian F Series RS1™ HDU Guidance and Steering Installation Manual
INSTALL FITTINGS IN THE STEERING VALVE
Before mounting the steering valve (P/N 334-0003-094) on the machine, install the proper fittings in the valve.
This prepares the valve for installation and simplifies the hose connection process later in the procedure.
FIGURE 1. Fittings Installed in the Steering Valve
NOTICE
The appearance of the steering hydraulic valve
may vary slightly from the images contained in
this manual. However, the fittings, hose
connections, and cable connections remain the
same.
Fitting Part Number Port
Fitting - -6 ORFS (M) to -6 SAE O-Ring (M) Straight Adapter 333-0012-084 LS STEER
Fitting - -4 ORFS (M) to -6 SAE O-Ring (M) Straight Adapter 333-0012-195 LSPV
Fitting - -6 ORFS (M) to -8 SAE O-Ring (M) Straight Adapter 333-0012-199 P, T
Fitting - -6 ORFS (M) to -10 SAE O-Ring (M) Straight Adapter 333-0012-233 A, B
Transducer - 0-3000 PSI Pressure 422-0000-086 PS
To Next Page
Loading...
Need help?
General
