Raymarine C-Series Reference Manual

Chapter 11: Automatic Identification System (AIS) 175
Local AIS alarms
When the connected AIS unit generates an alarm, your C-Series displays a local alarm
message and indicates the alarm status in the data bar icon:
To proceed:
1. Remove the message pop-up/display active alarm list:
2. Acknowledge the message at your AIS unit.
Important: An alarm remains active until it is acknowledge on the AIS unit.
Active alarm list
The active alarm list shows the status of each local alarm. This list can either be
accessed via the AIS Layer Setup Menu (see
page 176 ) or from the Alarms Setup Menu
(see
page 187 ).
Note: The local AIS alarms must be acknowledged at the AIS receiver. Removing the
message or adding it to the Alarm list on your C-Series display does not cancel the
alarm.
REMOVE
MESSAGE
VIEW AIS
ALARM LIST...
4nm North-Up (Relative Motion) Local
AIS message
AIS Local Alarm
This alarm must be acknowledged on your
AIS Receiver.
To remove this message press REMOVE
MESSAGE.
"AIS message"
D8968_1
AIS Alarm
active icon
D8967_1
REMOVE
MESSAGE
Removes pop-up, adds alarm to and displays AIS Alarm List
Removes pop-up and
adds alarm to AIS
Alarm List.
VIEW AIS
ALARM LIST...
Or
81221_4.book Page 175 Tuesday, February 28, 2006 5:24 PM

Raymarine C-Series Specifications

General

Brand	Raymarine
Model	C-Series
Category	GPS
Language	English