49
f. Turn the dial .The start time on the screen will change in increments of thirty (30) minutes. When the
desired start time appears on the screen, press the button to select and store it. Next, turn the dial
until the desired end time appears on the display. Press the button to select and store the end time.
Repeat this step to set the start and end times for more days.
Figure 45 – Setting Start and End Recirculation Times
g. Press and hold the button for two (2) seconds to store the time.
h. If all settings are stored, press to return to Standby Mode.
Figure 46– Storing Recirculation Run Time
▪3. Resetting the Recirculation Run Time
NOTE: This step is only necessary if the “Pro9” or “Auto” Recirculation Run Times need to be reset. If
“Auto” was selected the water heater will automatically program its recirculation operating patterns.
a. Enter the Recirculation Timer by pressing at Standby Mode while the water heater display is powered
on.
b. Turn the dial until “cLr” ashes on the screen. Press the button at the “cLr” screen to reset the
Recirculation Run Time. See Figure 47.
Figure 47 – Resetting the Recirculation Run Time
c. Turn the dial to “Pro9” or “Auto”. Press at the Recirculation Timer Type you wish to reset. See
Figure 48.
Chapter3HowtoUseTheControlPanel
To Next Page
Loading...
Need help?
General
