It is recommended that you use Web Image Monitor operating under the same network environment
as this machine. Otherwise, the Web browser may not open and an error may occur.
The default setting is Off.
1. Press [Facsimile Features].
2. Press [Reception Settings].
3. Press [Stored Reception File User Setting].
4. If you want to use a user code, press [On].
5. Press the Destination key of the user you wish to specify, and then press [OK].
6. Check the selected user, and then press [OK].
When a programmed user is deleted from the destination list, message "Deleted from Address
Book" is displayed. Enter the user again.
7. Press the [User Tools/Counter] key.
If the programmed user code was deleted using the Address Book Management function under
System Settings, you cannot view received and saved documents using Web Image Monitor.
Select [Off] in step 4 or reprogram the user code.
SMTP RX File Delivery Settings
This function is available on systems that allow routing of e-mail received via SMTP.
The default setting is Off.
For details about SMTP RX File Delivery Settings, see "SMTP RX File Delivery Settings".
2 Sided Print
Specify whether or not received fax documents are to be printed on both sides of the paper.
The default setting is Off.
Checkered Mark
Specify whether or not a checkered mark is to be printed on the first page of received fax documents.
The default setting is On.
Center Mark
Specify whether or not a center mark is to be printed halfway down the left side and at the top center
of each page received.
The default setting is Off.
Print Reception Time
Specify whether or not the received date, time, and file number are printed at the bottom of received
fax documents.
The default setting is Off.
Reception File Print Quantity
Specify the number of copies to be printed for each fax document received.
Reception Settings
133
To Next Page
Loading...
Need help?
General
