11. Appendix
This section explains maintenance and operation procedures for this printer. It also describes the
specifications of the printer and its options.
Moving and Transporting the Printer
• If the machine topples, or if a cover or other part gets broken, you must turn the power switch to
off and disconnect the power cord plug from the wall outlet. Then contact your service
representative and report the problem. Do not use the machine. Doing so could result in fire or
electric shock.
• The printer weighs approximately 29 kg (64.0 lb.). When moving the printer, use the inset grips
on both sides, and lift slowly in pairs. The printer will break or cause injury if dropped.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling
the cord can damage the power cord. Use of damaged power cords could result in fire or electric
shock.
• Unplug the power cord from the wall outlet before you move the machine. While moving the
machine, take care that the power cord is not damaged under the machine. Failing to take these
precautions could result in fire or electric shock.
• When moving the printer after use, do not take out any of the toners, nor the waste toner bottle
to prevent toner spill inside the printer.
• Be sure to disconnect all cables from the printer before transporting it.
• The printer is a piece of precision machinery. Take care to avoid damage during transportation.
• If optional paper feed units are attached, remove them from the printer and move them separately.
Repack the printer using its original packaging for transporting.
237
To Next Page
Loading...
Need help?
General