Attaching the Paper Feed Unit
• If the machine topples, or if a cover or other part gets broken, you must turn the power switch to
off and disconnect the power cord plug from the wall outlet. Then contact your service
representative and report the problem. Do not use the machine. Doing so could result in fire or
electric shock.
• The printer weights approximately 29 kg (64.0 lb.). When moving the printer, use the inset grips
on both sides, and lift slowly. The printer will break or cause injury if dropped.
• Unplug the power cord from the wall outlet before you move the machine. While moving the
machine, take care that the power cord is not damaged under the machine. Failing to take these
precautions could result in fire or electric shock.
• Do not place the machine on an unstable or tilted surface. If it topples over, an injury might occur.
• Lifting the paper feed unit carelessly or dropping it may cause injury.
• When one paper feed unit is installed, this detected as "Tray 2".
• The printer should always be lifted by two people.
• After a new paper feed unit has been installed, the driver settings might need to be reconfigured. For
details, see "Making Option Settings for the Printer", Driver Installation Guide.
• Tray 1 is required to print using the optional paper feed unit. Without Tray 1, paper jams will occur.
• Do not grip on the tray area when lifting the printer.
3. Installing Options
48
To Next Page
Loading...
Need help?
General