5. Press the [ ] or [ ] key to select [WEP], and then press [Details].
When activating the WEP setting, you will need to enter the WEP key. If you have not entered the key,
be sure to enter it.
6. Press [Enter].
7. Enter the characters, and then press [Accept].
• When entering a character, pressing [Accept] will mask it with an asterisk for security reasons.
• When using 64-bit WEP, up to 10 hexadecimal characters or five ASCII characters can be
entered. When using 128-bit WEP, up to 26 hexadecimal characters or 13 ASCII characters
can be used.
• Up to 10 or 26 hexadecimal characters and 5 or 13 ASCII characters can be entered.
• For ASCII character strings, uppercase and lowercase letters are differentiated, so be sure to
enter characters in the required case.
8. Press the [ ] or [ ] key to select [WEP], and then press the [OK] key.
9. Press the [Menu] key to return to the initial screen.
10. Print a configuration page to confirm the settings.
• The WEP key can also be set using a Web browser. For details, see Web Image Monitor Help.
• For details about printing the configuration page, see "Test Printing".
• p.43 "Test Printing"
Setting WPA
In the case of using WPA on a network, activate the WPA setting to be used for communication along with
WPA. Consult your network administrator for information about making authentication settings.
5. Configuration
94
To Next Page
Loading...
Need help?
General