Ricoh MP C6004 series User Manual

When Other Messages Appear
Message Cause Solution
"Firmware update will start.
Press [OK]. It will start
automatically after 30
seconds have elapsed."
Automatic firmware update
is enabled and it is the time
for an automatic update.
• If you want to start the firmware
update, press [OK], or configure
the setting so that the automatic
firmware update starts
automatically in 30 seconds.
• If you do not want to start the
firmware update, press [Cancel]
before 30 seconds elapse.
• Do not turn off the power switch
during the firmware update.
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
• The wireless LAN
board was not inserted
when the machine was
turned on.
• The wireless LAN
board was pulled out
after the machine was
turned on.
The settings are not updated
although the unit is detected.
Turn off the power, and then check the
wireless LAN board is inserted
correctly. After this, turn on the power
again. If the message appears again,
contact your service representative.
"Cannot connect with the
Bluetooth interface. Check
the Bluetooth interface."
• The Bluetooth interface
unit was installed while
the machine was turned
on.
• The Bluetooth interface
unit was removed while
the machine was turned
on.
Turn off the power, and then confirm
that the Bluetooth interface unit was
installed correctly. After this, turn on the
power again. If the message appears
again, contact your service
representative.
10. Troubleshooting
240

Ricoh MP C6004 series Specifications

General

Brand	Ricoh
Model	MP C6004 series
Category	All in One Printer
Language	English