Paper and Other Media
15
Loading Paper
This describes how to load paper into the paper tray and bypass tray.
Loading Paper in Tray 1 and the optional paper feed unit
The following example explains loading procedure for the standard paper tray
(Tray 1). The same procedure can be used for the optional paper feed unit.
❒ Make sure paper is not stacked above the limit mark inside the tray. Misfeeds
might occur.
❒ Do not put different types of paper in a single paper tray.
A Slowly slide out the paper tray (Tray 1), until it stops. Then, lift the front
of the tray slightly, and then pull the tray completely out.
Place the tray on a flat surface.
B Adjust the side guides and the end guide.
• Do not pull out the paper tray forcefully. If you do, the tray might fall and
cause an injury.
To Next Page
Loading...
Need help?
General