Rigol DS2000E Series User Manual

Chapter 13 System Function Setting RIGOL
DS2000E User’s Guide
13-7
USB Device
This oscilloscope can communicate with a PC or a PictBridge printer via the USB
Device interface on the rear panel. You need to set the oscilloscope to make it
match with different device types.
Press Utility  IO Setting  USB Device and use to select the desired
device type.
 Computer: in this type, the oscilloscope can communicate with the PC.
 PictBridge: in this type, the oscilloscope can communicate with the PictBridge
printer.
GPIB Address
When using the GPIB mode to control the oscilloscope, you need to extend a GPIB
interface for the oscilloscope using the USB-GPIB interface converter (need to be
ordered separately).
To set the GPIB address of this interface, press Utility  IO Setting  GPIB and
use to input the desired address. The default is 1 and the range is from 1 to 30.

Rigol DS2000E Series Specifications

General

Brand	Rigol
Model	DS2000E Series
Category	Test Equipment
Language	English