RIGOL Chapter 14 Remote Control
DS2000E User’s Guide
Remote Control via USB
1. Connect the device
Use a USB cable to connect the oscilloscope with your PC via the USB Device
interface.
2. Install the USB driver
This oscilloscope is a USB-TMC device. After you connect the oscilloscope to the
PC and turn both on for the first time (the oscilloscope is automatically
configured to USB interface; at the same time, make sure that Utility IO
Setting USB Device is set to "Computer"), the Found New Hardware
Wizard as shown in the figure below is displayed on the PC. Please install the
"USB Test and Measurement Device (IVI)" driver following the directions in the
wizard. The steps are as follows.
1
2
To Next Page
Loading...
Need help?
General
