Before you start playing
18
r
FR-1x V-Accordion
After connecting any cable to the FR-1x, be sure to
never place it on the side when not using it.
•Always stand the V-Accordion on its rubber feet (and in
the corresponding direction) to avoid damaging the
plugs.
•Always handle and move the FR-1x with care and pay
special attention to the cable slack to avoid damaging
or bending the cables.
• If you place the FR-1x on your lap, ensure that the
audio and adapter cables run between your legs (not
sideways) to avoid damaging or bending the cables.
Attaching the straps
Proceed as follows to attach the straps to your FR-1x:
1.
Unpack the straps.
The FR-1x comes with two straps, each with two
ends: the upper end is fitted with a Velcro strip and
the clip, the lower end is not. See the illustration
below:
2.
Put the FR-1x on a stable surface as shown
in the illustration below.
3.
Slide the upper end (with the Velcro strip) of
one strap through the left holder ring (see
the illustration).
4.
Attach the strap’s upper part to the Velcro
layer below it.
Important remark
Left holder ring
FR-1x GB.book Page 18 Tuesday, November 8, 2011 11:44 AM
To Next Page
Loading...
Need help?
General
