Using the FR-1x’s audio player
34
r
FR-1x V-Accordion
3.
Use register [1] (√ VALUE) or [2]
(VALUE ®) to select the desired audio file.
(In the example above, the display shows the first
three characters of a file called “Scarborough.mp3”.)
The display shows the first three characters of the file
name you selected. If you select another audio file
while playback of the previously selected file is still
running, the audio player stops. See page 71 for how
the FR-1x displays the characters of the selected file
name.
To check whether you have selected the correct audio
file, start playback ([®÷π]).
NOTE
The audio files are displayed based on the following sorting
order: numbers, capital letters, small letters.
NOTE
You can only select audio files in the USB memory’s root
directory. Audio files inside folders are not detected.
4.
Press the [SET] register to leave the FR-1x’s
PARAMETER mode.
Adjusting the playback level
1.
Press and hold the [SET] register to enter
PARAMETER mode.
The display shows the name of the last parameter
you selected.
2.
Use treble register [3] or [4] (PARAM LIST)
to select the following parameter:
NOTE
Pressing registers [3] and [4] (PARAM LIST) simultaneously
alternates between “AUd” (first parameter of the PARAME-
TER group) and “ESq” (first parameter of the MIDI group).
This may come in handy to “close in” on the parameter you
need.
3.
Use register [1] (√ VALUE) or [2]
(VALUE ®) to set the playback level.
The setting range is: Off, 1~10. If you select “Off”, the
audio file will be inaudible.
4.
Press the [SET] register to leave the FR-1x’s
PARAMETER mode.
sCa
PIANO/GUITAR
WIND
AUL
8
FR-1x GB.book Page 34 Tuesday, November 8, 2011 11:44 AM
To Next Page
Loading...
Need help?
General
