Loading User Set memories from USB memory (optional)
V-Accordion
r
41
4.
Use treble registers [1] and [2] (VALUE) to
select the file number of the User Programs
you want to load.
If the USB memory doesn’t contain any User Program
files, the display shows “---” instead of a number.
5.
Press the [USER PROGRAM] (ENTER) button
to load the selected User Programs.
The display shows “Lod” (Load), then “don” (Done),
after which the FR-1x returns to the main page.
Loading User Set memories from
USB memory (optional)
The FR-1x allows you to copy individual Sets from a
USB memory to the four internal “USER” Set locations.
The Set files (with the extension “.ST3”) must first be
copied to a USB memory’s root directory before loading
them into the FR-1x’s “USER” area.
1.
Insert an optional USB memory into the
FR-1x’s USB MEMORY port.
2.
Press and hold down the [SET] register.
The display shows the name of the last parameter
you selected.
3.
Use treble register [3] or [4] (PARAM LIST)
to select “USt” (User Set).
4.
Use treble registers [1] and [2] (VALUE) to
select the file number of the Set you want
to load.
If the USB memory doesn’t contain any Set files, the
display will show “---” instead of a number.
5.
Press the [USER PROGRAM] (ENTER) button
to confirm your selection.
The FR-1x suggests “USER” memory “1” as target for
the Set file.
6.
Use treble registers [1] and [2] (VALUE) to
select the desired target memory (1~4).
7.
Press the [USER PROGRAM] (ENTER) button
to load the selected Set.
The display shows “Lod” (Load), then “don” (Done) to
indicate that the file was loaded successfully. Next,
the FR-1x returns to the main page. See “Selecting
Sets” on p. 24 for how to recall the settings of the
desired User Set.
NOTE
See “Restoring the User Sets to their factory defaults” on
p. 64 if you want to recover the FR-1x’s original User Sets
at a later stage.
PIANO/GUITAR
WIND
Ust
FR-1x GB.book Page 41 Tuesday, November 8, 2011 11:44 AM
To Next Page
Loading...
Need help?
General
