Royal Enfield Bullet 350 User Manual

34
ASSEMBLING THE HEAD LAMP BULB
1. Refix the new halogen
bulb into reflector unit of
the headlamp.
2. Gently press the bulb
holding clip and lock the
free end in its slot.
3. Fit the rubber grommet.
4. Connect the electrical
connections carefully &
assemble the headlamp
in the reverse order of
dismantling.
 Disconnect the wiring
coupler over the bulb.
 Remove the rubber grommet from the bulb.
 Press the clip by thumb to release the free end
from bulb holder.
 Pull out the bulb.
HEADLAMP BULB REPLACEMENT
 Loosen the rim
holding screw on top
and take out the head
light reflector.
For 12 V 5Ah Ba tteri es:
 Do not overfill the battery electrolyte as it will spill
ou t through the over flow pipe and c au se
corrosion to motorcycle parts.
 Clean the wire terminals free of corrosion and
keep the terminals coated with petroleum jelly.
CHANGING ELECTRICAL COMPONENTS
MINOR MAINTENANCE TIPS
C AU T I O N
Never touch the bulb with your fingers,
Finger prints will etch the glass and
decrease bulb life. Always hold the
bulb with paper or clean dry cloth
during handling.

Royal Enfield Bullet 350 Specifications

General

Engine Type	Single Cylinder, 4 Stroke, Air Cooled
Displacement	346 cc
Max Power	19.1 bhp @ 5250 rpm
Max Torque	28 Nm @ 4000 rpm
Transmission	5 Speed Constant Mesh
Fuel Capacity	13.5 Liters
Brakes Rear	153 mm Drum
Tyre Size Front	3.25 x 19
Tyre Size Rear	3.25 x 19
Seat Height	800 mm
Ground Clearance	135 mm
Wheelbase	1370 mm
Brakes Front	280 mm disc
Fuel System	Fuel Injection