Royal Enfield Bullet 350 User Manual

38
PRECAUTIONS
 Wash motorcycle when the engine is cold.
 Cover the silencer, tail pipe, carburetor, horn and
control switches with suitable plastic bags and tie
it firmly to prevent water entry.
 Remove ignition key and seal key hole using
adhesive tape.
 Brush engine area with a solvent to remove dirt or
grease.
 Use low pressure jet of water to clean.
 Never spray water with great force on head lamp,
speedometer, flasher lights, front and rear wheel
hubs, electrical connections and wires, control
cables, carburetor, spark plug, battery etc.
 Do not apply any corrosive solvent on painted
surfaces or rubber parts.
 Use luke warm water and mild detergent on the
painted components to remove dirt, etc.
 Rinse motorcycle thoroughly with plain water to
remove the detergent.
 If possible, use compressed air and blow off water
particles from the obscure areas of the motorcycle,
electrical connections etc.
AFTER WASHING
 Ensure, the motorcycle is thoroughly dry by wiping
with a clean soft absorbent cloth or chamois leather.
 Remove all plastic bags and adhesive tapes.
 Lubricate control cables, pivot and rear chain with
lube oil
 Polish the painted and plated surfaces using
polishing wax.
 Start engine and allow to run at idling speed for a
few minutes to warm up engine.
 Drive the motorcycle slowly, applying both brakes
intermittently to dry up the water in the brake shoes.
WASHING PROCEDURE

Royal Enfield Bullet 350 Specifications

General

Engine Type	Single Cylinder, 4 Stroke, Air Cooled
Displacement	346 cc
Max Power	19.1 bhp @ 5250 rpm
Max Torque	28 Nm @ 4000 rpm
Transmission	5 Speed Constant Mesh
Fuel Capacity	13.5 Liters
Brakes Rear	153 mm Drum
Tyre Size Front	3.25 x 19
Tyre Size Rear	3.25 x 19
Seat Height	800 mm
Ground Clearance	135 mm
Wheelbase	1370 mm
Brakes Front	280 mm disc
Fuel System	Fuel Injection