Samson 2417 Series User Manual

EB 2517 EN 43
Servicing
7.5 Tightening torques
Î RefertoFig.3
Component
Width across
ats
Valve size/actuator area
Tightening
torque inNm
Nut (7.2) SW30 DN15to100 10
Cap screw (7.3) 3mm DN15to100 5
Nuts for pillars (8.2) SW24 DN15to100 60
Fastening nuts (9) SW16 DN15to100 25
Control line connection (11) – 40to640cm² 22
Diaphragm plate nut (14) SW12 40to640cm² 40
Nuts and bolts (15) – 40to640cm² 25
7.6 Lubricants and sealants
SAMSON's After-sales Service department
can support you concerning lubricants and
sealants approved by SAMSON.
7.7 Accessories
Table8: Assignment of compensation
chamber (18) to regulator, with item no.
Type2413 Actuator
Actuator area A
Item number
∙Compensation
chamber
DN15 to 50 DN65 to 100
640cm² 1190-8789 1190-8790
320cm² 1190-8788 1190-8789
160,80,40cm² 1190-8788
Note
7.8 Preparation for return
shipment
Defective devices can be returned to
SAMSON for repair. Proceed as follows to
return devices to SAMSON:
1. Put the regulator out of operation (see
section9.1).
2. Decontaminate the regulator. Remove
any residual process medium.
3. Fill in the Declaration on Contamination.
The declaration form can be downloaded
from our website at uwww.samson.de>
SERVICE&SUPPORT>After-sales
Service.
4. Sendthedevicetogetherwiththelled-in
form to your nearest SAMSON
subsidiary. SAMSON subsidiaries are
listed on our website at
uwww.samson.de>Contact.

Samson 2417 Series Specifications

General

Brand	Samson
Model	2417 Series
Category	Control Unit
Language	English