TV SETTING
SETTING COLOUR SYSTEM
In case of abnormal sound, you may try to adjust the sound system.
Press◄or►buttontoselectAUTO, PAL or SECAM until
the proper colour effect is reached.
2
1
Navigate to ATV Manual Tuning submenu, press ▲ or ▼
button to highlight System-C item.
Press RED button to save.
3
SETTING SOUND SYSTEM
Normally it is unnecessary to set colour system. However, if abnormal colour occurs, you may try to adjust
the colour system.
Press◄or►buttontoselectDK, I or BG until the proper
sound effect is reached.
2
1
Navigate to ATV Manual Tuning submenu, press ▲ or ▼
button to highlight System-S item.
Press RED button to save.
3
Fine-Tune is not necessary under normal conditions. However, in area of inferior broadcast conditions
where adjustment is necessary for a better picture and sound effect, use Fine-Tune.
FINE TUNING
Press ◄or ► button to finetuneuntil the best possible
picture and sound are obtained.
2
1
Navigate to ATV Manual Tuning submenu, press ▲ or ▼
button to highlight Fine-Tune item.
Press RED button to save.
3
Used to remove unwanted channels from the channel scanning memory.
SKIP
Press ▲ or ▼
button to select Skip item. Press ◄ or ►
button to select Yes.
2
1
Navigate to ATV Manual Tuning submenu, press ▲ or ▼
button to highlight Current CH item. Press◄or►button
to select a channel positon in which you want to skip.
Press RED button to save. The Channel set as SKIP
will not appear when pressing CHANNEL UP (▲) or
CHANNEL DOWN (▼) button.
3
To Next Page
Loading...
Need help?
General
