EasyManuals Logo
Home>Sega>Video Game>F355 Challenge

Sega F355 Challenge User Manual

Sega F355 Challenge
143 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
55
www.seuservice.com
10. CONTROL PANEL (HANDLE MECHA)
When securing the Control Panel, be careful so as not to get your fingers or hands
pinched in.
In cases the Steering operability is poor and the adjustment of VOLUME SETTING in the
TEST mode has no effect, the causes may be the volume gear's mesh failure and or volume
malfunctioning. Adjust volume gear mesh or replace the volume as per the following
procedure. In this product, when the steering wheel is moved fully left/right, if the volume shaft
is rotating within the movable range, the volume is not feared to be damaged. Secure the
volume in the manner the volume shaft is oriented as shown and the gears are appropriately
engaged when the steering wheel is in the centering position allowing the car to go straight
forward.
10 - 1 REMOVING THE CONTROL PANEL
Turn the power switch off.
Remove a total of 4 Tamperproof
Screws from both sides of the
Control Panel's front part.
Remove the 2 Tamperproof
Screws from the underside of the
Control Panel.
Wiring Connectors are connected
inside the Control Panel. Carefully
draw the Control Panel in the
manner not to damage the wiring.
Disconnect the wiring connector.
Before starting to work, ensure that the Power SW is OFF. Failure to observe
this can cause electric shock or short circuit.
Use care so as not to damage wirings. Damaged wiring can cause electric
shock or short circuit.
Do not touch undesignated places. Touching places not designated can cause
electric shock or short circuit.
This work should be performed by the Location's Maintenance Man or
Serviceman. Performing work by non-technical personnel can cause electric
shock hazard.
This unit is a heavy item weighing approximately 22kg. and therefore, be very
careful when performing the work. Use plural workers.
Immediately after the game is finished, the motor may still be very hot. When
performing the removal work, wait until the motor cools off.
TAMPERPROOF SCREW (2) black
M8 X 30, w/flat washer
TAMPERPROOF SCREW (4) black
M8 X 30, w/flat & spring washers.
FIG. 10. 1
5
4
2
1
3

Other manuals for Sega F355 Challenge

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sega F355 Challenge and is the answer not in the manual?

Sega F355 Challenge Specifications

General IconGeneral
BrandSega
ModelF355 Challenge
CategoryVideo Game
LanguageEnglish

Related product manuals