71
www.seuservice.com
When performing work, be sure to turn power off. Working with power on
can cause electric shock and short circuit hazards.
The Fluorescent Lamp, when it gets hot, can cause burn. Be very careful
when replacing the Fluorescent Lamp.
Be sure to use lamps of the designated rating. Using lamps of undesignated
rating can cause a fire or malfunctioning.
To perform work safely and securely, be sure to prepare a step which is in a
secure and stable condition. Performing work without using the step can cause
violent falling down accidents.
15.
REPLACING THE FLUORESCENT LAMP
When performing work,
be sure to use a step.
FIG. 15 a
FIG. 15 b
Turn off power.
Take out 3 truss screws to open the
BILLBOARD LID, and the
fluorescent lamp can be replaced.
TRUSS SCREW (3) black
M4 X 8
BILLBOARD LID
FLUORESCENT LAMP
FLUORESCENT LAMP 40W: 390-5251-40-01
GLOW BULB: 390-5638-4P
2
1
To Next Page
Loading...
Need help?
General
