PRECAUTIONS WHEN MOVING THE MACHINE
33
7
PRECAUTIONS WHEN MOVING THE MACHINE7
● Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing fire or
electric shock.
● To move the unit over the floor, pull in the adjustors and have the casters con-
tact the floor. While moving the unit, be careful that the casters do not roll over
the power cord or the ground wire. If cord or wire is damaged, there could be
electrical shocks and/or short circuits.
● When crossing a sloped or stepped area, disconnect the PTV from the Main
Cabinet. If you tilt them while connected together, the connection points may
be damaged and personnel could be injured.
● When lifting the cabinet up steps, you must hold it by the designated handles or
by the bottom surface. Lifting it by any other area may lead to damage or dis-
figuration to that part or surrounding parts due to the weight of the cabinet and
could also lead to injury of personnel.
● When tilting the cabinet to move it across a sloped or stepped area, always use
at least two people. Attempting such an operation alone can lead to accident
or injury.
● When moving the components separately, take care concerning the direction
you push the DLP and Seat Cabinet in. These elements may fall over, causing
damage or an accident.
● When moving the components do not push any of the plastic elements or
shaped parts. Do not use them to pull the components along either. This may
damage the parts or the surrounding parts and this could lead to accidents or
injury.
● After dividing the components to move them, do not use the Control Units in the
Main Cabinet to push or pull the cabinet. This may damage or disfigure these
parts and lead to malfunctions or injury.
● Do not use the Controller Holders to move the cabinet, in doing so may dam-
age or disfigure them..
7-1 MOVING THE MACHINE
To Next Page
Loading...
Need help?
General
