64
PROJECTOR
10
REMOTE CONTROL BUTTONS
10.1
● If adjustment to the PTV is necessary, direct the remote control’s light emitting
portion towards the PTV screen.
AUTO COLOUR MATCHING
10.2
The Projector may be subject to colour deviations affected by earth magnetism, the
building steel frames, etc. When the Projector is initially installed or the Projector’s
installation position is changed, have the colour matching performed automatically.
Keep pressing the P button (red) for approximately 3 seconds
to have the ensuing movements performed automatically.
The Projector will shift to the colour deviation correction
mode from the game mode, with the green cross pattern
appearing on the screen.
The cross pattern moves up/down and right/left to start
the movement of searching the correct screen position and
inclination.
When the green cross pattern movements are finished, similar
detection is performed sequentially in order of red and then
blue cross movements.
After detecting by green, red and blue cross movements, the
game mode returns with the colour deviation status being
corrected.
Although very rarely, the TRY AGAIN error display in red may appear. At this time, press the P button (red)
for approximately 3 seconds. Even after the above operation is repeated, if the error condition still exists, then
the display shifts to PLEASE ADJ. In this case, the auto colour matching function can not be used. Contact the
place of contact herein stated or where the product was purchased from.
If the automatic colour matching indicates an error, colour matching can manually be performed.
Refer to CONVERGENCE ADJUSTMENT (manual colour matching).
To Next Page
Loading...
Need help?
General
