8
ASSEMBLY AND INSTALLATION
6
Use three screws to fasten the POP to the cabinet. Use a step when carrying out this procedure.
6-1-1 ATTACHING THE POP
6-1-1 FIG. 01
6-1 INSTALLING THE CABINET
6-1-2 SECURING IN PLACE
Be sure to ground the adjusters, and secure the product fi rmly to the installation location. If the cabinet moves
either during assembly work or during operation after the completion of assembly, a serious accident may occur.
1
Move the product to the installation site. See Chapter 2 for examples of installation.
Ensure that you leave enough aisle space for the player to sit in the seat. Additionally, leave at least 200 mm of
space on the side of the cabinet with the exhaust vent (the rear surface of the cabinet) for ventilation.
2
Use a wrench to set adjuster heights so that the unit will stay level.
3
After setting, turn adjuster nuts upwards to tighten them and secure adjuster heights.
6-1-2 FIG. 02
ADJUSTER CASTER
About 5 mm
Tighten nut
upwards.
ADJUSTER
8-32 x1/2" Phillips Truss head
POP
Black (7)
To Next Page
Loading...
Need help?
General
