2
PRECAUTIONS REGARDING INSTALLATION LOCATION
2
PRECAUTIONS REGARDING INSTALLATION LOCATION
2
● This product is an indoor game machine. Do not install it outside. Even indoors, avoid installing in places men-
tioned below so as not to cause a fi re, electric shock, injury and/or malfunction.
- Places subject to rain or water leakage, or places subject to high humidity in the proximity of an indoor swim-
ming pool and/or shower, etc.
- Places subject to direct sunlight, or places subject to high temperatures in the proximity of heating units, etc.
- Places fi lled with infl ammable gas or vicinity of highly infl ammable/volatile chemicals or hazardous matter.
- Dusty places. Sloped surfaces. Places subject to any type of violent impact.
- Vicinity of anti-disaster facilities such as fi re exits and fi re extinguishers.
- Areas where the temperature exceeds the applicable temperature (ambient temperature) range of 5 to 30
degrees centigrade.
2-1 LIMITATIONS OF USAGE
● Be sure to check the Electrical Specifi cations. Ensure that this product is compatible with the location's power sup-
ply, voltage, and frequency requirements. A plate describing Electrical Specifi cations is attached to the product.
Non-compliance with the Electrical Specifi cations can cause a fi re and electric shock.
● This product requires a breaker and earth mechanism as part of the location facilities. Using the product without
these can cause a fi re and electric shock.
● Ensure that the indoor wiring for the power supply is rated at 15 A or higher (AC single phase 100 V ~ 120 V area).
Non-compliance with the Electrical Specifi cations can cause a fi re and electric shock.
● Be sure to use an independent power supply equipped with an earth leakage breaker. Using a power supply
without an earth leakage breaker can cause an outbreak of fi re if a power surge occurs.
● Putting many loads on one electrical outlet can cause generation of heat and a fi re resulting from overload.
● When using an extension cord, ensure that the cord is rated at 15 A or higher (AC 100 V ~ 120 V area). Using a
cord rated lower than the specifi ed rating can cause a fi re and electric shock.
BACK SIDE
To Next Page
Loading...
Need help?
General
