48
TEST MODE
12
12-3-4 FORCE FEEDBACK
● FORCE:
Set the STEERING resistance. The ** indicates the
current resistance setting.
The smaller the value, the weaker the resistance; the
larger the value, the stronger the resistance.
(Minimum value is 0; the maximum value is 10. The
default setting is 4.)
Move the cursor to UP or DOWN and press the TEST
Button to change the value.
● FORCE TEST:
Verifi es the STEERING motor is working properly.
Toggle between OFF and ON by aligning to CENTER
and pressing the TEST Button.
The STEERING will rotate and stop in the center posi-
tion. Pressing the SERVICE Button moves the cursor
to the next menu item and CENTER changes to OFF.
Control of the STEERING is then released.
When the RIGHT menu item is ON, the STEERING
rotates to the right as far as possible and then stops.
Press the SERVICE Button again to turn it OFF and
release control of the STEERING.
When the LEFT menu item is ON, the STEERING ro-
tates to the left as far as possible and then stops. Press
the SERVICE Button again to turn it OFF and release
control of the STEERING.
Move the cursor to EXIT and press the TEST Button to
return to the Game Test Menu Screen.
12-3-4 FIG. 01
● When you select “FORCE FEEDBACK”, a connection test runs and the STEERING rotates.
● When the connection check completes, a screen below is displayed, and you may adjust the STEERING resis-
tance.
FORCE FEEDBACK
(MIN 0 : MAX 10 : DEFAULT 4)
FORCE =
*
*
UP
DOWN
FORCE TEST (FORCE =
*
*
)
CENTER OFF
RIGHT OFF
LEFT OFF
―
> EXIT
SELECT WITH SERVICE BUTTON
AND
PRESS TEST BUTTON
Select INPUT ASSIGNMENTS to display the following screen.
12-3-5 INPUT ASSIGNMENTS
**H displays one of 256 different values for each input
control from 00H to FFH.
[0.1.2.3.4.5.6.7.8.9.A.B.C.D.E.F]
STEERING:
Adjust the centering of the STEERING control.
GAS PEDAL, BRAKE PEDAL:
Adjust the GAS and BRAKE pedals.
Move the cursor to EXIT and press the TEST Button
to return to the Game Test Menu Screen.
12-3-5 FIG. 01
INPUT ASSIGNMENTS
STEERING
**
H
GAS PEDAL
**
H
BRAKE PEDAL
**
H
―
> EXIT
SELECT WITH SERVICE BUTTON
AND
PRESS TEST BUTTON
To Next Page
Loading...
Need help?
General
