Sharp LC-32LB370U User Manual

18
LC-32LB370U/LC-50LB370U Sharp 32"/50" LED TV
Connecting an antenna or cable TV (no box)
1 Make sure that your TV’s power cord is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT / CABLE jack on the back of your TV and to the antenna or cable TV
wall jack.
3 Plug your TV’s power cord into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press
S or T to highlight TV, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See “Automatically scanning for channels” on page 48.
Coaxial cable
Antenna or cable TV
(no box)
Back of TV
Coaxial cable
connector
ANT / CABLE
jack
On your TV
Notes
• Use a coaxial cable to eliminate interference and noise from radio
waves.
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service
personnel to correct the problem.
• If the signal level for a channel is weak, the picture may be distorted.
Adjust the antenna or use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on others, the
problem may be caused by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a set-top box and
experience poor picture quality, you may need to install a set-top box to
improve signal reception and picture quality. Contact your cable or
satellite TV provider about upgrading to a set-top box.
• Many high-definition (HD) channels upscale standard-definition (SD)
content. The picture displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as it would be if the
content was originally recorded in HD.

Sharp LC-32LB370U Specifications

General

Comb filter	3D
Screen shape	Flat
Response time	- ms
Display diagonal	31.5 \
Display brightness	- cd/m²
LED backlighting type	Direct-LED
Supported video modes	1080p
Contrast ratio (dynamic)	2000000:1
Screen format adjustments	16:9
Supported graphics resolutions	1920 x 1080 (HD 1080)
Motion interpolation technology	-
3D type	Active
Tuner type	Analog & digital
Number of tuners	2 tuner(s)
Analog signal format system	NTSC
Digital signal format system	ATSC
Audio system	DTS Sound
Audio decoders	DTS
RMS rated power	5 W
Number of speakers	2
HDMI ports quantity	3
DVI-D ports quantity	0
USB 2.0 ports quantity	1
Consumer Electronics Control (CEC)	Aquos Link
On Screen Display (OSD) languages	ENG, ESP, FRE
Product color	Black
Panel mounting interface	100 x 100 mm
AC input voltage	120 V
AC input frequency	60 Hz
Power consumption (standby)	1 W
Power consumption (typical)	47 W

Weight and Dimensions

Depth (with stand)	184 mm
Height (with stand)	464 mm
Weight (with stand)	5100 g
Depth (without stand)	64 mm
Width (without stand)	727 mm
Height (without stand)	437 mm
Weight (without stand)	4900 g