Servicing
Note
Operation characteristics can vary widely. For this reason, only gene
intervals can be specified here.
ral maintenance
Maintena
Regreasi
As a standard feature, the machines have rolling-contact bearings which are
permanently lubr rease (UNIREX N3, made by ESSO). A regreasing
device is pos mation about
relubrication l data
on the ratin
Note
Do not mix d
nce
(optional) ng
General
icated with g
sible as an option. In this case, you can find infor
intervals, quantities and types of grease, and, if required, additiona
plate or lubricant plate.
ifferent types of grease!
g
Prolonged storag uce the useful life of the bearing grease. Check the
condition of t r more than 12
months. If th ntaminated,
immediate
on perman
(Page
No
R
egr
1. Clea
2. Pre data).
● Pleas on on the rating and lubricant plates.
● Regreasing s rried out when the machine is running (max. 3600 rpm)!
e periods red
rease if the ehe g quipment has been in storage fo
e grease is found to have lost oil content or to be co
re
en
lubrication must be carried out before commissioning. For information
tly-greased bearings, please refer to the section titled Bearings
18).
te
easing
n the grease nipples at the drive end and non-drive end.
ss in the type and quantity of grease specified (see rating/lubricant plate
e observe the informati
hould be ca
The bearing
after the exc
Cleaning
Cleaning the greasing channels and used grease chambers
The used grease collects outside each bearing in the used grease chamber of the
outer bearing cap. When replacing bearings, remove the used grease.
NOTICE
temperatur
e rises sharply at first, then drops to the normal value again
ess grease has been displaced out of the bearing.
You have to separate the active parts of the bearings to replace the grease that is in
the greasing channel.
Standard machines_Operating_Instructions_Compact
56100000002001 EN, 01/2010
17
To Next Page
Loading...
Need help?
General