EasyManuals Logo
Home>Siemens>Cell Phone>S46

Siemens S46 User Manual

Siemens S46
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
2.10.02 06-S46 Body.fm i 37 Eagle Am Engl, A31008-H5450-A5-2-4A19
12
Getting Started
Insert battery
Insert battery into the phone
(
and
).
Replace battery cover and push
gently in the direction of the
arrow
until it clicks.
Charge battery
The battery is not fully charged when
delivered. To charge your phones
battery:
Plug the supplied charger into the
device interface at the bottom of
the phone and plug the power
supply into the outlet. (Use only
the charger supplied with your
phone and charge for at least
two hours).
After charging, disconnect the
charger from the phone by
squeezing the top and bottom of
the charger connector and pulling
it out of your phone.
Charging
Your phone’s display shows the following:
s
When charging is in progress.
r
When charging is complete.
An empty battery is fully charged after
approximately two hours. Charging is only
possible when the temperature is between
41°F and 104°F (5°C and 40°C). (The
charge icon flashes as a warning when the
temperature is above or below the stated
values.) The voltage specified on the power
supply unit must not be exceeded.

Table of Contents

Other manuals for Siemens S46

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens S46 and is the answer not in the manual?

Siemens S46 Specifications

General IconGeneral
BrandSiemens
ModelS46
CategoryCell Phone
LanguageEnglish

Related product manuals