Siemens S7-1200 User Manual

CP 1243-7 LTE
Operating Instructions, 01/2015, C79000-G8976-C381-01
105
Diagnostics and upkeep
6
6.1
Diagnostics options
The following diagnostics options are available:
LEDs of the module
For information on the LED displays, refer to the section LEDs (Page 28).
STEP 7: The "Diagnostics" tab in the Inspector window
Here, you can obtain the following information on the selected module:
● Entries in the diagnostics buffer of the CPU
● Information on the online status of the module
STEP 7: Diagnostics functions via the "Online > Online and diagnostics" menu
On the diagnostics pages, you can obtain static information on the selected module:
● General information on the module
General information on the module
● Diagnostics status
Information on the diagnostics status
● Ethernet port
Address and statistical information

Siemens S7-1200 Specifications

General

Digital Inputs	Integrated in CPU or via signal modules (SM)
Digital Outputs	Integrated in CPU or via signal modules (SM)
Analog Inputs	Integrated in CPU or via signal modules (SM)
Analog Outputs	Integrated in CPU or via signal modules (SM)
Communication	PROFINET
Communication Ports	1 x PROFINET
I/O Modules	Signal Modules (SM)
Programming	STEP 7
Power Supply	24V DC
Operating Temperature	0°C to 55°C
Expansion Modules	Communication Modules (CM), Battery Modules (BM)

Summary

Application and properties

Connecting the S7-1200 to a mobile wireless network

Connects S7-1200 controller to mobile wireless networks (LTE, UMTS, GSM).

Communications services

Details telecontrol and direct communication via mobile networks.

Other services and properties

Performance data and configuration limits

Requirements for operation

Lists hardware, software, and contract requirements for using the CP.

Installation, connecting up, commissioning

Important notes on using the device

General safety and operational notices, including overvoltage protection.

Installing the CP and commissioning

Step-by-step guide for installing the CP and initial commissioning.

Configuration and operation

Configuration in STEP 7

Overview of configuring the CP using SIMATIC STEP 7 software.

Information required for configuration

Details necessary information for configuring the CP and telecontrol system.

Configuration of the TeleService access

Configuring data points and messages

How to configure data points and messages for CPU communication.

Datapoint types

Process image, type of transmission, event classes, triggers

Describes image memory, send buffer, data transmission types, and event triggers.

Connection establishment

Calling a TeleService connection

Security functions

Overview of security features like VPN, firewall, and secure protocols.

STEP 7 configuration of individual parameters

Configuration of specific functions through STEP 7 parameter groups.

Programming the program blocks

Program blocks for OUC

TC_CONFIG for changing configuration data of the CP

IF_CONF: SDT for the configuration data of the CP

Diagnostics and upkeep

Diagnostics options

Overview of diagnostic tools including LEDs, STEP 7, and Web server.

Downloading firmware

Module replacement

Technical specifications

General technical specifications

Technical specifications - wireless interface (CP 1243-7 LTE-EU)