Siemens S7-1200 User Manual

Installation, connecting up, commissioning
3.2 Installing the CP and commissioning
CP 1243-7 LTE
36 Operating Instructions, 01/2015, C79000-G8976-C381-01
3.2
Installing the CP and commissioning
Prior to installation and commissioning
WARNING
Read the system manual "S7-1200 Programmable Controller"
Prior to installation, connecting up and commissioning, read the relevant sections in the
system manual "S7-1200 Programmable Controller", refer to the documentation in the
Appendix.
When installing and connecting up, keep to the procedures described in the system manual
"S7-1200 Programmable Controller".
Configuration
One requirement for the commissioning of the CP is the completeness of the STEP 7 project
data (see below). You should also read the section "Configuration and operation (Page 41)".
Inserting the SIM card
Note
Inserting and removing the SIM card
Do not insert or r
emove the SIM card while the CP is operating.

Siemens S7-1200 Specifications

General

Digital Inputs	Integrated in CPU or via signal modules (SM)
Digital Outputs	Integrated in CPU or via signal modules (SM)
Analog Inputs	Integrated in CPU or via signal modules (SM)
Analog Outputs	Integrated in CPU or via signal modules (SM)
Communication	PROFINET
Communication Ports	1 x PROFINET
I/O Modules	Signal Modules (SM)
Programming	STEP 7
Power Supply	24V DC
Operating Temperature	0°C to 55°C
Expansion Modules	Communication Modules (CM), Battery Modules (BM)