3.4.3 Activate routing
Until now, only Layer 2 communication has functioned via the access router.
However, the structure of the network makes it essential to communicate over
Layer 3. Otherwise, data exchange between the network segments will not be
possible.
Enable Layer 3 routing as follows:
1. Go to the menu item "Layer 3 (IPv4) > Configuration" and then to the "General"
tab.
2. Tick the "Routing" checkbox. By enabling routing, VRRPv3 will be used
automatically.
3. Click the "Set Values" button.
To Next Page
Loading...
Need help?
General