Operating a project
8.1 Operating a project on OP 73micro
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
105
8.1.2 Setting the project language
Introduction
The HMI device supports multilingual projects. You need to configure a corresponding
operator control object which lets you change the language setting on the HMI device during
runtime.
The project always starts with the language set in the previous session.
Requirements
● The relevant project language must be available on the HMI device.
● The language changeover function must be logically linked to a configured operator
control object such as a button.
Selecting a language
You can change project languages at any time. Language-specific objects are immediately
output to the screen in the relevant language when you switch languages.
The following options are available for switching the language:
1. A configured operator control object switches from one project language to the next in a
list.
2. A configured operator control directly sets the desired project language.
Further information on this may be available in your plant documentation.
8.1.3 Entries and help within a project
8.1.3.1 Overview
Procedure
Values are entered in the project input fields. The values are transferred from the input fields
to the PLC.
Proceed as follows:
1. Select the required input field on the screen.
Based on your configuration, you can enter the following type of values in the input field:
– Numerical
– Alphanumerical
– Symbolic
– Date/time
2. Set the value.
3. Confirm your entries with
ENTER
or cancel your entries with
ESC
HELP
.
To Next Page
Loading...
Need help?
General
