Configuring the operating system
6.2 Configuring the operating system for the TP 177micro
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
85
6.2.2.4 Calibrating the touch screen
Introduction
Depending on the mounting position and viewing angle, it is possible that parallax may occur
when operating the HMI device. In order to prevent any operating errors as a result, calibrate
the screen again in the startup phase or during runtime.
Requirements
The "OP" icon on the Control Panel has been touched.
Procedure
Proceed as follows:
1. Open the "OP Properties" dialog, then select the "Touch" tab.
1
2
Figure 6-18 "OP Properties" dialog, "Touch" tab
① If the HMI device does not react precisely to a touch, the touch screen may require
calibration.
② Button for calibrating the touch screen
2. Touch the "Recalibrate" button.
3. Follow the instructions on the HMI device screen.
4. Close the dialog with
.
Result
The HMI device touch screen is now recalibrated.
To Next Page
Loading...
Need help?
General
