Start-Up 09.02
4-40 Siemens AG 6SE7087-6AK85-1AA0
Rectifier/Regenerating Unit Operating Instructions
4.3.9.4 Hardware configuration (P052 = 4)
This function is used to select option boards (SCB, CB, TB) in the rectifier/regenerating unit electronics box.
In order to install these modules, an LBA bus coupling (Local Bus Adapter) is required for the electronics box
(see Section 9.1)!
All parameters, which can be written into the "Hardware configuration" status ("H", refer to the right-hand
column in the parameter list in Chapter 5), can be changed.
The "hardware configuration" selection can be realized in the "Switch-on inhibit", "Ready-to-switch" or "Fault"
status
Procedure:
⇓ P052 = 4 Function selection Hardware configuration
⇓ P051 = 3 Access stage Expert mode ( to change the following parameters)
⇓ Set the parameters to configure the optional board (see Section 4.5 or the
operating instructions for the board)
⇓ P090 = Board, slot 2 (To the RIGHT
in the electronics box!)
P091 = Board, slot 3 (In the CENTER
in the electronics box!)
Parameter values for P090/P091:
0: No option board
1: CB Communications board
2: TB Technology board (only P090
)
3: SCB Serial Communication Board
⇓ Additional parameters, depending on the option boards (refer to the associated Instruction
Manuals or Section 4.5)
⇓ P052 = 0 Function selection return
⇓ P key The operating display appears (r000) while parameters and interval variables
are being re-assigned
- The hardware is initialized
If error/fault message F050, F070 or F080 appears: see Chapter 7
⇓ After the selected function selection has been completed, the "Switch-on inhibit" (008) or
"Ready-to-switch-on" (009) operating display appears.
AoteWell Automation Sales Team
Buy Siemens PLC HMI Drives at AoteWell.com
To Next Page
Loading...
Need help?
General