Machine data
2.4 Axis-specific machine data
Parameter Manual
210
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
The value entered in this MD defines the path of an increment which applies
when an axis is traversed with the JOG keys in incremental mode or with the
handwheel.
The path traveled by the axis on each increment each time the traversing key
is pressed or for each handwheel detent position is defined by the following
parameters:
• MD31090 $MA_JOG_INCR_WEIGHT
(Weighting of an increment of a machine axis for INC/handwheel)
• Selected increment size (INC1, ..., INCvar)
The possible increment stages are defined globally for all axes in MD11330
$MN_JOG_INCR_SIZE_TAB [n] and in SD41010 $SN_JOG_VAR_INCR_SIZE.
Entering a negative value reverses the direction of evaluation of the tra-
verse keys and the handwheel rotation.
Related to:
MD11330 $MN_JOG_INCR_SIZE_TAB
SD41010 $SN_JOG_VAR_INCR_SIZE
Description: The input value is used to define the distance of an increment which, when
traversing an axis during active transformation using the JOG keys, is valid
for the incremental dimension or via handwheel.
The distance, through which the axis traverses when executing the incremental
dimension with transformation active, depending on the traversing key actu-
ated or handwheel grid position, is defined by the following parameters:
• MD31092 $MA_JOG_INCR_WEIGHT_TRAFO
(Evaluating an increment of a machine axis for INC/handwheel)
• selected increment size (INC1, ..., INCvar)
The possible increment steps are globally defined for all axes in MD11330
$MN_JOG_INCR_SIZE_TAB [n] or in SD41010 $SN_JOG_VAR_INCR_SIZE.
Entering a negative value reverses the direction evaluation of the traversing
keys and/or the handwheel direction of rotation.
The set value is only effective, if this is > 0 ist. For values of zero, then
MD31090 $MA_JOG_INCR_WEIGHT is effective
Corresponds with:
MD11330 $MN_JOG_INCR_SIZE_TAB
MD31090 $MA_JOG_INCR_WEIGHT
SD41010 $SN_JOG_VAR_INCR_SIZE
31090 JOG_INCR_WEIGHT A01, A12 H1,G2
mm, degrees Evaluation of an increment with INC/handwheel DOUBLE Reset
CTEQ
- 2 0.001, 0.00254 - - 2/2
31092 JOG_INCR_WEIGHT_TRAFO A01, A12 H1,G2
mm, degrees Evaluation of an increment for INC/handwheel for active
transformation
DOUBLE Reset
CTEQ
- 2 0.0, 0.0 - - 2/2
To Next Page
Loading...
Need help?
General
