Mounting
7.3 Assembly and disassembly with different mounting systems
SIRIUS - SIRIUS 3RA load feeders
72 Manual, 09/2016, A5E03656507520A/RS-AB/003
Design of the adapter type for reversing contactor assembly
The DIN rail adapters can be connected without the need for tools. It is only necessary to
insert link wedges and lateral modules on the rear of the adapter (depending on size).
The following are required to connect two DIN rail adapters:
● In sizes S00 and S0: Two link wedges
● In size S2: Two lateral modules and four link wedges
● In size S3: Three side modules and six link wedges
Figure 7-27 Connection of DIN rail adapters (size S00 and S0)
Figure 7-28 Connection of DIN rail adapters (size S2)
To Next Page
Loading...
Need help?
General