Mounting
7.3 Assembly and disassembly with different mounting systems
SIRIUS - SIRIUS 3RA load feeders
Manual, 09/2016, A5E03656507520A/RS-AB/003
83
The procedure for disassembling the DIN rail adapter with mounted reversing starter of
size S2 is shown in the figure below. You require a screwdriver for disassembling.
①/② Press the locking devices down with a screwdriver. Then push the DIN rail adapter with
mounted feeder forwards against the pressure of the mounting spring.
③ Pull the DIN rail adapter with mounted feeder forwards with a swivel action.
④ Press the DIN rail adapter with mounted feeder upwards and remove the DIN rail adapter
with mounted feeder from the DIN rail.
7.3.2.3 Mounting direct-on-line starters and reversing starters on DIN rail adapters (size S3)
Mounting the DIN rail adapter on the DIN rail
The DIN rail adapter snaps onto the DIN rail (no tools are required).
To Next Page
Loading...
Need help?
General